🌀 Washer not spinning

⚠️ Common Causes

Lid switch failed, drive belt broken, drain pump blocked (won't spin if full of water), motor coupler failed, control board issue

🔧 Parts to Check

• Lid switch
• Drive belt
• Drain pump
• Motor coupler
• Motor

🔧 Troubleshooting Steps

1. Check lid switch — washer will not spin with lid open. Test for continuity with multimeter
   ✓ Expected: 0Ω when switch depressed (lid closed)
2. Check for error code — many washers show codes like 'LE' (motor locked) or 'UE' (unbalanced)
   ✓ Expected: Note any code displayed
3. Check if washer drained completely — washer won't spin if tub is full of water
   ✓ Expected: Tub should be dry
4. If not drained, clean drain pump filter — remove debris blocking pump
   ✓ Expected: Pump clear, water drains
5. Check drive belt (top-load) — belt should be tight and intact, not broken or slipping
   ✓ Expected: Belt tight, no cracks
6. Check motor coupler (top-load Whirlpool) — plastic coupler between motor and transmission, should not be sheared
   ✓ Expected: Coupler intact, not broken
7. Test motor windings with multimeter — should read 2-20Ω (see component resistance table)
   ✓ Expected: Within range

💡 Related Resources

• Look up error codes for your appliance
• Component failure reference — ohm ranges and test procedures
• All troubleshooting guides — browse by appliance type
• Find service manuals for your specific model