🌀 Washer not agitating

ModerateStep-by-step troubleshooting guide — 5 steps, Washer, Moderate difficulty.

⚠️ Common Causes

Lid switch failure, broken drive belt, worn transmission coupler, motor relay failure

🔧 Parts to Check

Lid/door switch
Drive belt
Transmission coupler
Motor relay

🔧 Troubleshooting Steps

Check lid switch: open multimeter to continuity mode, test lid switch terminals while pressing switch — should beep when closed
Inspect drive belt: remove rear panel, check belt is intact and not slipped off pulleys
Test transmission coupler: remove transmission, inspect plastic coupler for worn/broken splines
Check motor relay on control board: listen for clicking when starting cycle
If all above OK, control board likely defective — replace

💡 Related Resources

Look up error codes for your appliance
Component failure reference — ohm ranges and test procedures
All troubleshooting guides — browse by appliance type
Find service manuals for your specific model