🌀 Samsung washer displays 5E error (temperature sensor)

🔧 Troubleshooting Steps

1. Disconnect power. Access the temperature sensor (NTC thermistor) — typically located on the water inlet area or inside the tub
   ✓ Expected: Sensor accessible
2. Measure the sensor resistance with a multimeter at room temperature (~70°F/21°C). Samsung NTC sensors should read approximately 10kΩ ± 5% at 25°C
   ✓ Expected: Resistance in range (10kΩ at 25°C)
3. Check for open circuit (OL) or short circuit (0Ω) — both indicate a failed sensor
   ✓ Expected: No OL or 0Ω reading
4. Check the wiring harness between the sensor and the main control board for broken wires or corroded connectors
   ✓ Expected: Wires intact, connectors clean
5. Replace the temperature sensor if resistance is out of spec. Samsung sensors are model-specific — match the part number
   ✓ Expected: New sensor installed, 5E code cleared

💡 Related Resources

• Samsung manuals & error codes — model-specific documentation
• Look up error codes for your appliance
• Component failure reference — ohm ranges and test procedures
• All troubleshooting guides — browse by appliance type
• Find service manuals for your specific model