♨️ GE dryer displays F11 error (no heat, electric)

🔧 Troubleshooting Steps

1. Measure the heating element resistance. Should read 10-30Ω. Infinite = open, replace element
   ✓ Expected: 10-30Ω
2. Check the thermal cutoff (one-way thermal fuse). Should read 0Ω. Open = blown, replace. DO NOT replace without finding the overheating cause
   ✓ Expected: 0Ω — cutoff intact
3. Check the high-limit thermostat. Should read continuity at room temperature. Open = replace
   ✓ Expected: Continuity at room temp
4. If all components test good, check for 240V at the element during a heat cycle. No 240V = control board relay issue
   ✓ Expected: 240V AC at element
5. Check the vent for lint restriction. A blocked vent causes the dryer to overheat, which can blow the thermal cutoff. Clean the entire vent path from dryer to outside
   ✓ Expected: Vent clear, good airflow at outside vent

💡 Related Resources

• GE manuals & error codes — model-specific documentation
• Look up error codes for your appliance
• Component failure reference — ohm ranges and test procedures
• All troubleshooting guides — browse by appliance type
• Find service manuals for your specific model