🌀 Electrolux washer displays E01 error (drain error)

🔧 Troubleshooting Steps

1. Clean the drain pump filter. Electrolux has a filter at the bottom front — remove the cap, drain water, clear debris
   ✓ Expected: Filter clean
2. Check the drain hose routing — no higher than 96 inches, no kinks
   ✓ Expected: Hose properly routed
3. If E01 persists, check the drain pump. Electrolux uses a sealed pump — if the impeller is broken or the motor is seized, replace the pump
   ✓ Expected: Pump runs, water drains
4. Check the pressure switch (water level sensor) on the top of the tub
   ✓ Expected: Diaphragm free
5. If all above check out, the control board's drain pump relay may be failing
   ✓ Expected: Control board relay functional

💡 Related Resources

• Electrolux manuals & error codes — model-specific documentation
• Look up error codes for your appliance
• Component failure reference — ohm ranges and test procedures
• All troubleshooting guides — browse by appliance type
• Find service manuals for your specific model