Whirlpool Washer Error Codes: F Codes and How to Fix Them
Whirlpool (and sister brands Maytag, Amana, Admiral, Roper) use a two-part error code format: F (fault) + a letter + E (error). The letter identifies the specific subsystem. Here's the complete reference.
F-Code Quick Reference
| Code | Subsystem | Meaning | DIY Fix |
|---|---|---|---|
| F0E1 | Wiring | Control board communication fault | Unplug 5 min. If recurs, control board issue — service call |
| F0E2 | Wiring | Motor tachometer signal lost | Check motor wiring. If secure, motor or control board — service call |
| F1E1 | Drain | Drain pump not draining in time | Clean drain pump filter. Check drain hose for kinks or clogs |
| F1E2 | Drain | Water level sensor not responding | Check pressure switch hose for air leaks or clogs |
| F2E1 | Water | Water not filling to level | Check inlet valves fully open. Clean inlet filters. Check water pressure |
| F2E2 | Water | Water level sensor stuck | Unplug 5 min. Check pressure switch. If recurs, sensor replacement |
| F5E1 | Drain | Drain timeout — pump not working | Clean pump filter. Check drain hose. If persists, pump replacement |
| F6E1 | Motor | Motor overcurrent / stall | Check drum is not stuck. If free, motor or drive belt issue |
| F6E2 | Motor | Motor overheat | Let washer cool 1 hour. Check ventilation. If recurs, motor issue |
| F7E1 | Control | Control board fault | Unplug 5 min. If recurs, control board replacement needed |
| F8E1 | Water | Water inlet valve not opening | Clean inlet filters. Check valve with multimeter (should read 15-30Ω) |
| F9E1 | Drain | Drain hose clogged or kinked | Inspect entire drain hose path. Straighten kinks. Clean clogs |
| F9E2 | Drain | Drain pump failure | Replace drain pump. Technician recommended |
| F0E9 | General | General fault — see second digit | Refer to specific code. Unplug 5 min to clear |
How to Read Whirlpool Codes
Whirlpool displays the code in two parts. The first part (F0-F9) indicates the fault area. The second part (E1-E9) indicates the specific error. For example:
- F1 = Drain system. E1 = pump not draining. Combined: F1E1 = drain pump timeout
- F2 = Water system. E1 = water not filling. Combined: F2E1 = fill timeout
Reset Procedure
- Turn washer off
- Unplug for 5 minutes
- Plug back in
- Press Power
Maytag / Amana note: These brands use the same F-code system as Whirlpool. The codes in this table apply to all Whirlpool Corporation brands.